Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register. We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Well..after 9 long months of labor, my AE-21 hit the water for it's maiden voyage !! I spent 4 hours and a tank of gas getting to know her! I was running 50/1 break in oil so I couldn't run hard...but I did make a few 6000 rpm passes...just enought to pack some air and get the hull to "fly" !! I have a few bugs to work out..stuck pop it valve, bad sending unit for water temp, need to secure my rear bench seat bottom from sliding around, etc. but all worked out great! The boat drew attention everywhere we went!! Here's some pictures:
!! I spent 4 hours and a tank of gas getting to know her! I was running 50/1 break in oil so I couldn't run hard...but I did make a few 6000 rpm passes...just enought to pack some air and get the hull to "fly" 
!! I have a few bugs to work out..stuck pop it valve, bad sending unit for water temp, need to secure my rear bench seat bottom from sliding around, etc. but all worked out great! The boat drew attention everywhere we went!! Here's some pictures:
):
