1986 blazer won't get on pad easy

[cottontop58]

Have a blazer 17ft with a 200 evinrude bored over, the boat will jump on plane super quick but going a speed of 25 the nose is up a little but when u gas on it the front sucks down in the water and eventually it popps up a little like it gets on pad it's like a barge going through the water ? Has a 20 pitch prop

[ Post made via iPhone ]

[idvette]

How's the transom?

[ Post made via iPhone ]

[cottontop58]

Seems solid , has a solid sound and I can mash down on it and it will throw the boat out of the water but at 40 -50 there is water spray all the way up to the front till u hit about 56 it pops up and seem like it on pad cause it's starts trying to chine

[ Post made via iPhone ]

[cottontop58]

The cavitation plate on foot is even with the notch bottom above the actual pad

[ Post made via iPhone ]

[idvette]

The only 2 reasons I can think of for your issue are the boat is severely overweight or the transom is flexing. I'd say it's time to have a good look at the boat

[ Post made via iPhone ]

[cottontop58]

I raised the motor up a knotch should that help

[ Post made via iPhone ]

[cottontop58]

Took the blazer out and notice when on plain and u stomp it that tail end raises up which make the front sit down then eventually the front popps up and kinda tries to chine a little my motor is screaming with that 20 pitch going 55

[ Post made via iPhone ]

[cottontop58]

3 blade 20 pitch raker

[ Post made via iPhone ]

[idvette]

Might be a stupid question, but is the trim stuck full down?

[ Post made via iPhone ]

[cottontop58]

No it trims up I put a 24 pitch power tech 4 blade on it yesterday and it turned the prop and had a lot more lift when I would stomp it it would stay up better with that prop but loose in the tail end , the 20 pitch ran 55mph pretty straight didn't gps the 24 gonna run it again weekend

[ Post made via iPhone ]