Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
VECTOR Measurements please help!!!
-
- The new guy
- Posts: 13
- Joined: Aug 27, 2010 12:46 pm
VECTOR Measurements please help!!!
Ok so Im doing a recore on my Vector and someplace along the line my measurement sheet disappeared between home, work and my shop. Anyway I need to know how far forward the front cross member goes from the dashboard. I believe its still marked on my hull but grinding and extra layers I do want to be sure. And the important one is how far back from the dash does the floor start (theres a footwell I guess you call it right below the drivers feet also be where the front of the stringers end). Any help would be great.
Re: VECTOR Measurements please help!!!
Hmm? Mine didn't have a foot well. I know I ran my floor up under the dash so I could mount the foot throttle in a more comfortable position. My vector is a 1980, from seeing recore picsfrom others it does look like some years were different though. As for the stingers I can try to find my pics or take some measurements later today for you.
[ Post made via Android ]
[ Post made via Android ]

-
- The new guy
- Posts: 13
- Joined: Aug 27, 2010 12:46 pm
Re: VECTOR Measurements please help!!!
My stringers ran from the rear to this foot well then about 2 1/2- 3 feet to the front bulkhead. This is the measurement I need. Where the stringer ends to the bulk head. I can roughly see where the bulkhead was but cannot see where the front of the stringers ended.
-
- Random Topics
- Replies
- Views
- Last post
-
- 2Replies
- 4433 Views
- Last post by Hippie459MN
Sep 06, 2011 10:58 am
-
- 7Replies
- 7157 Views
- Last post by Hippie459MN
Sep 06, 2011 10:28 pm
-
- 3Replies
- 5068 Views
- Last post by 77viper
Sep 07, 2011 8:19 pm
-
- 1Replies
- 4212 Views
- Last post by Hydrostream Bot
Sep 07, 2011 10:04 pm
-
- 1Replies
- 4280 Views
- Last post by Hydrostream Bot
Sep 08, 2011 8:16 am