1987 Hydrostream Voyager

Post: # 20623Post **wheely** » Oct 15, 2014 4:58 am

thinking of putting a jack plate just wondering which setback would be the best putting a new 200 ETEC Ho thank you

[ Post made via Android ]

Oct 17, 2014 10:57 am

good to see an evinrude comeback!

Oct 18, 2014 8:15 pm

Welcome,

For top speed?
Without knowing anything else about your setup, the answer is a lot.
Both the Vpad and XT will take 10 or more, maybe a little less with a heavy motor.

Post: # 20638Post **Rut311969** » Oct 19, 2014 4:53 pm

Im running a 225 ho etec with no set back and no modds and hitting 76-78 mph 85 Voyager.

Post: # 20688Post **wheely** » Nov 02, 2014 8:09 pm

what prop you running with your 225 Ho

Post: # 21234Post **Newowner20** » Oct 03, 2015 10:37 am

Just bought a 82 voyager 150 merc mounted direct onto transom at lowest setting, need some advice for props, I have a 17 and 25 pitch laser prop at the moment but would like to find a good all around prop 3-4 or five blade?

[ Post made via iPhone ]

Post: # 21240Post **terry2** » Oct 03, 2015 10:32 pm

83 voyager 200 merc.25p 4 blade trophy 68-69 gps

Post: # 21246Post **Newowner20** » Oct 04, 2015 1:41 pm

How is it out of the hole with that prop

[ Post made via iPhone ]

Post: # 21249Post **terry2** » Oct 04, 2015 8:17 pm

hits hard out of the hole,on plane like right now.guy I bought the boat off of had a 26p chopper no jack plate was ok but I think I get better performance with this prop.these boats like the prop shaft about 2 1/2 inches below the pad.i had to raise my motor when I got the boat guy had it over 4 inches below the pad world of difference.lot of info on hydrostream.org on set ups on voyager,good luck

Post: # 21253Post **Newowner20** » Oct 07, 2015 10:53 am

Thanks for the info, was considering raising the motor

[ Post made via iPhone ]

Hydrostreamforums.com - The only dedicated Hydrostream forum

Hydrostreamforums.com - The only dedicated Hydrostream forum