Hydrostreamforums.com - The only dedicated Hydrostream forum

Ok so Im doing a recore on my Vector and someplace along the line my measurement sheet disappeared between home, work and my shop. Anyway I need to know how far forward the front cross member goes from the dashboard. I believe its still marked on my hull but grinding and extra layers I do want to be sure. And the important one is how far back from the dash does the floor start (theres a footwell I guess you call it right below the drivers feet also be where the front of the stringers end). Any help would be great.

Hmm? Mine didn't have a foot well. I know I ran my floor up under the dash so I could mount the foot throttle in a more comfortable position. My vector is a 1980, from seeing recore picsfrom others it does look like some years were different though. As for the stingers I can try to find my pics or take some measurements later today for you.

[ Post made via Android ]

My stringers ran from the rear to this foot well then about 2 1/2- 3 feet to the front bulkhead. This is the measurement I need. Where the stringer ends to the bulk head. I can roughly see where the bulkhead was but cannot see where the front of the stringers ended.