Hydrostreamforums.com - The only dedicated Hydrostream forum

I'm rebuilding my viper going to put in a 4 or 6 piece stringer system with 2 possibly 4 of them having knees to tie in the transom. If anyone gas pictures of theirs I'm open to suggestions besides the ones that I have drawn out and the others still in my head have not been put on paper yet

[ Post made via Android ]

Check out my "restoring Ventura 2" thread half way down the page. I did a stringer setup and beat it up all summer. Holding up very well. Going to take it out after work today.

[ Post made via Android ]

Thanks Nosboss that tread was really helpful that's about what I had in mind already have built up hull with 2 later of woven roven niw for stringers and paint my project is 79 viper motor it's 1989 Marc 200 28pitch clear 5 inch setback manual jackplate hope to break the 80's Valero runs I'm high 60's maybe 70 I'm good smooth day in black creek middleberg Florida thanks for the link no-one else seems to want to give any help our just the obviously smartass comment thanks

[ Post made via Android ]

No problem. I don't think the stringer setup is very popular around here so maybe that's why nobody replied. I'm happy my core will never get wet again.

BTW, my Ventura has been to 90mph turning a 28 trophy. 80 shouldn't be a problem for you.

[ Post made via Android ]

Another stringer boat here, see the Vector in my sig that runs 85 in the quarter with a stock 200XRi. Hell the Vamp is getting a stringer set up too. No core for this guy.

I'm doing a Venture II. Getting core and stringers. Should be fast as $hit. Bill

I did a Viper stringer and core rebuild. Has yet to be tested though as it is not completely finished yet. http://hydrostreamforums.com/viewtopic.php?f=13&t=2090

^ check out that viper. Amazing work. absolutely mind boggling

aaron78viper wrote:^ check out that viper. Amazing work. absolutely mind boggling

I agree. Makes mine look like junk. Lol

[ Post made via Android ]