pulling block on 2.4
Posted: Nov 01, 2012 11:15 am
hey guys, well .....as happy as i am with my motor, im thinking about doing some engine mods and have a few questions/thoughts i figured id run by you guys.
the motor is a 2.4 200 block set on a 135 mid and lower. i believe that the tuner and plate has not been changed. i was thinking about doing this myself and im curious how hard of a task this would be. ive been told i would have to change the studs and of course new gaskets. while i had the block off i figured id put a lightweight cowl on.
is there anything else that needs to be done?
any suggestions otherwise?
difficulty level?
what tuner to use? bobs?
im completely fine with the 2:1 lower. the hole shot is great and great accerlation. i think with a few mods and the right prop i could see 90 easily which is my goal.
thanks
cody
the motor is a 2.4 200 block set on a 135 mid and lower. i believe that the tuner and plate has not been changed. i was thinking about doing this myself and im curious how hard of a task this would be. ive been told i would have to change the studs and of course new gaskets. while i had the block off i figured id put a lightweight cowl on.
is there anything else that needs to be done?
any suggestions otherwise?
difficulty level?
what tuner to use? bobs?
im completely fine with the 2:1 lower. the hole shot is great and great accerlation. i think with a few mods and the right prop i could see 90 easily which is my goal.
thanks
cody