Re: Project Hydrostream Vulture
Posted: Nov 25, 2020 6:04 pm
I know I havent posted a ton of updates here but trust me, a lot has happened and I will get all caught up eventually but I want to knock a few more things out before then and sadly with winter and cold weather upon us here in Minnesota, boat work is pretty much done for till spring.
But with that said, I did pick up a lower from Scott Bilda (bruzercomp81) this summer that already had a nose cone on it but just needed the body work done to it and me not being a body man, I sent it off to Arron at Xtreme Paint and Body here in Wyoming MN. Yes, he is a HUGE boat guy and Hydorstream nut and was a very good friend with Howard for those of you that dont know him. I picked up the lower from Aaron today and he more than knocked it out of the park on this one. Its still in primer cause I haven't decided what im going to do with it yet but he got it all done, and also got the torque tab installed too. Huge thank you to both Scott and Aaron!
Before...
After...
I can't wait to get this thing on the water this spring.
But with that said, I did pick up a lower from Scott Bilda (bruzercomp81) this summer that already had a nose cone on it but just needed the body work done to it and me not being a body man, I sent it off to Arron at Xtreme Paint and Body here in Wyoming MN. Yes, he is a HUGE boat guy and Hydorstream nut and was a very good friend with Howard for those of you that dont know him. I picked up the lower from Aaron today and he more than knocked it out of the park on this one. Its still in primer cause I haven't decided what im going to do with it yet but he got it all done, and also got the torque tab installed too. Huge thank you to both Scott and Aaron!
Before...
After...
I can't wait to get this thing on the water this spring.