Hydrostreamforums.com - The only dedicated Hydrostream forum

Lol. Well that's a good question. The power I put on my boat changes with the wind. I used to run a super mod v4 shown in the pic on the previous page. It ran great and went 84mph on my boat but it also ran on race gas so I decided to upgrade to a stock gt 150 v6 on a 16 inch mid. It ran just a little slower just way cheaper to run. But last year that blew up so now I'm in the processe of modifying it a little so it is faster then my old v4 just not running on race gas.

[ Post made via Android ]

Bruzer comp post some pics if you don't mind

This was right after we first hung the v6 on it.

[ Post made via Android ]

Seeing that boat never gets old. That top picture I think is the only one I have seen of it without a lot of air under it.

Thanks bruzercomp that vandal is really nice and clean want mine to look like that some day

Thanks guys! I really love the boat. It is a blast to drive and will always keep it just needs new gel at some point. So hydromirk, what are you planning for your vandal?

[ Post made via Android ]

Let's see center steer ether dual cable or cable and pulley steering two seats one behind the other.full core and floor with stringers.i would love to hope up a v4 with a short mid and racing lower and bored over with mad efi

Are you thinking v4 looper or v4 crossflow? And I have a really good guy that shortens mid sections. And are you planning on having exposed stringers or a floor over the stringers? And are you using this just for drag racing or all around use?

[ Post made via Android ]

I'm not sure if I want to go with looper v4 power or cross flow I'm thinking looper I'm going to be racing and on weekends maybe run around the river and I think I'm going with a stringer bottom and a floor mount for the seats not shire yet,any suggestions bruzercomp

Well I suggest going with a looper. I went with a crossflow and maxed it out at mid 80's but I know a guy running a looper at closer to 90 on a heavier Ventura II and he is still running on pump gas. And for the floor I would just run a regular floor. I went with the stringer set up and all said and done ended up using the same amount of wood on the floor as we would have on a floor and its way harder to work on and mount things too.

[ Post made via Android ]