Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.

Registering only takes a few minutes and you can do so by CLICKING HERE

If you are a member, don't forget to log in to take full advantage of the forum.

220 Magnum EFI trim tilt motor

The place for mechanics, racers, or anyone seeking engine-related technical help.
Post Reply
User avatar

Topic Author
LFP
The new guy
The new guy
Posts: 5
Joined: Jun 20, 2013 7:25 pm
Location: Seattle

220 Magnum EFI trim tilt motor

Post: # 18690Post LFP »

Secured the motor with rope above, angle iron on port side, modified 2x4 and door wedges on transom. Removed port bracket w/o mishap. 2 of 4 brushes in pump motor had seized with verdigris at contact points between steel brush springs and brass brush holders: electolysis. Cleaned, bit of grease at contacts but not on brushes, works fine.
Top
Post Reply

  • Random Topics
    Replies
    Views
    Last post

Return to “Engine Tech”