Hey everybody.
So I finally got the '85 Jcraft into the water this weekend with a 2003 mercury 150 XR6 on it. At the dealership they had said everything checked out with the motor. Saturday night I drove it around and it was fine and docked it for the night at the cottage. Sunday morning I went to go fill up on gas, got to the marina fine but on my way back the motor just died... it began to make this "clicking" noise and did not sound right at all. I turned to motor off and turned it back on again and it seemed to be fine.. but a little bit down again it died. I managed to get it back to the dock going about half throttle but it really did not sound right. When I tilted the motor up when it was docked I noticed water coming out of the rigging hoses area..a felt the water and it was warm. I left it there for a while and went back to it later that day. Turned the motor on and it idled fine. Did not take it out in fear something might happen.
Does anybody know what this might mean?
Patrick
Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
Strange Clicking Noise
-
- Hydrostream Addict
- Posts: 299
- Joined: Jun 10, 2009 10:35 am
- Location: Savannah,Ga.
- Been thanked: 1 time
Re: Strange Clicking Noise
Compression, spark, and fuel flow. These are the the basics of your outboard. Start with these until you narrow down to what is wrong. If you rule them out you have an internal engine problem. From what you have said, it sounds like a fuel issue.
Re: Strange Clicking Noise
Run it at the dock with the cowl off to isolate where the noise is coming from, and you can check for water leaks. Does it do it just under load or all the time?
Samari on s&f
Chet Olson
75 viper 2.4 200, 130 shot of NOS
91 vegas loaned out
79 vking project 2.5 280
Chet Olson
75 viper 2.4 200, 130 shot of NOS
91 vegas loaned out
79 vking project 2.5 280
Re: Strange Clicking Noise
not all the time... it was still making the noise when I had made it back to the dock.. it sounds like the engine is running really heavily (for lack of a great description) its not a very smooth idle/running more of a clunky running.
________________________________
1985 JCraft Pro Ski
150 Mercury XR6

1985 JCraft Pro Ski
150 Mercury XR6


-
- Random Topics
- Replies
- Views
- Last post
-
- 76Replies
- 45271 Views
- Last post by WillPardy
Mar 27, 2019 9:59 am
-
- 24Replies
- 39706 Views
- Last post by Pierce
May 06, 2020 11:38 pm
-
- 9Replies
- 10734 Views
- Last post by 427man
Mar 21, 2017 5:42 pm
-
- 4Replies
- 7111 Views
- Last post by AdamDK
Mar 23, 2017 4:41 am
-
- 4Replies
- 10201 Views
- Last post by aaron78viper
Oct 09, 2017 10:23 am