Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.
Registering only takes a few minutes and you can do so by CLICKING HERE
If you are a member, don't forget to log in to take full advantage of the forum.
bilge pump fitting
-
rocketman4u
- The new guy
- Posts: 12
- Joined: Jun 13, 2012 12:38 am
- Location: florida
bilge pump fitting
hello i have a 1984 vector but i noticed the boat doesn't have a hull fitting for the bilge pump.got a new bilge pump and hose cause boat didn't have one when i got boat. i also noticed boat sits low in water in the back. was wondering if anyone knows the proper location for the hull fitting. thank you
-
Surface Scratcher
- Hydrostream Addict
- Posts: 344
- Joined: Apr 11, 2009 11:17 pm
- Location: Central Texas
- Has thanked: 1 time
Re: bilge pump fitting
...could be wrong but I don't think they typically installed those at the factory, so its your call. 
In the past, I have rigged them to dump it in the motor well. Then it would drain out from there. It worked well and I didn't have to make a hole in the side of the boat. 
In the past, I have rigged them to dump it in the motor well. Then it would drain out from there. It worked well and I didn't have to make a hole in the side of the boat. -
rocketman4u
- The new guy
- Posts: 12
- Joined: Jun 13, 2012 12:38 am
- Location: florida
Re: bilge pump fitting
thanx surface scratcher i was thinking the same thing cause boat sits low in the water 
-
- Random Topics
- Replies
- Views
- Last post
-
- 8Replies
- 50015 Views
- Last post by 427man
Oct 30, 2015 11:53 am
-
- 10Replies
- 24067 Views
- Last post by LSaupe
Mar 31, 2013 5:19 am
-
- 2Replies
- 15084 Views
- Last post by Hippie459MN
Mar 13, 2013 2:00 pm
-
- 1Replies
- 7167 Views
- Last post by V pads
Mar 13, 2013 8:32 pm
-
- 9Replies
- 14490 Views
- Last post by XcellR8
Mar 14, 2013 6:56 pm