its a sportsmaster cone made for sandy areas that way it will kindly wash itself out should be fine but for sure going to be watch it and chet got a ? for ya off topic when i hooked my throttle cable up my merc is idleing bout 1200 rpm witch seems high so there are 3 screws on the throttle arm i believe wot screw,idle stop screw and whats the other how do i go bout idleing this down some and smoothing it out like it didnt want to rev up smoothly and help would be great an a place maybe to get a free manual for a 95 mercury 200 efi

I'm interested on how high you can run that cone, I would think the top holes would suck air. Watch your WP.

Very nice

Sounds good mercman, lets see some pictures with it rigged out. As for as your prop you could send to Hoss props in Ok. or Hopkins props in covington, La.

yea was made buy some ppl that had the molds far as i no i got the mercury on her and running got her fired up with tnriverrat sunday mourning purrred like a kitten lower unit turned fine just got to get me a new fuel cell/gastank and put my lowwater pickup on thats post to arrive tomorr with a torque tamer cavation plate anyone no were to get my hoss 14.5/28 chopper turned and rebalanced at before the summer hits

It's a knock-off of a Hydrostream. HSP would be correct. Am I correct??? OOPS!! Guess that was already determined.
Still a nice boat.

laz is the first 3 which on the web site just said lousinal homemade boats so idk who actually replicated the hull the whole hin# laz67657c606

The first 3 letters will be the manufacturer check it here to find out who it was http://www.uscgboating.org/recalls/mic1.aspx