Hydrostreamforums.com - The only dedicated Hydrostream forum

Im looking for some feedback on surface props. I've got a Vegas with an 86 225 evinrude on it, looks to be a 4 or 5" setback with a hydraulic backplate and low water pickups. I want to get a surface prop but am wondering What pitch because props aren't cheap. Or if any one has anything they were looking to get rid of, I would gladly buy it. Thanks

[ Post made via Android ]

27 srx if you can find one. A 28 chopper would be my second choice.

[ Post made via Android ]

You'll have to excuse my lack of knowledge as surface props are pretty much a new thing to me. What do you mean by srx? Also what height should the motor be set at.

[ Post made via Android ]

A srx is a omc prop that us no longer made thus a little hard to find.

Start with the propshaft even with the pad, go up from there.

[ Post made via Android ]

SRX's are no longer made? Didn't know that. thanks

From talking with DAH propeller, they made this prop for OMC, but I think Bombardier didn't want to continue with it. Took them out of high performance in the stock sense.. sort of. E-Tech doesn't really have any high perf propellers now.

I got a couple 28 Chopper props for sale,but you have to drill the spline out of OMC application......one Merc chopper....one MACH Chopper

We were talking about your mach the other day im not sure if I wanna go used or new. Obviously used is wayyy cheaper. I was told Hoss makes a decent prop and customer service is excellent with getting you setup right . But again this is just what I've heard.

[ Post made via Android ]

yup used is way cheaper you could get these 2 chopper and still have about $200 left in your pocket over new

This is the skimpy end of the month $$$ wise for me but Ill shoot You a message and see if you still got one of them left in 2 weeks or so

[ Post made via Android ]