Hydrostreamforums.com - The only dedicated Hydrostream forum

Looking good Kenny, looks like your a professional, keep the pics coming

[ Post made via iPhone ]

Here is the latest update. The core in the front is all glassed in and done. The core in the back is all glued down and will be glassed over today I hope. I am almost out of resin and dont think I have enough to do the whole job so I am going to wait. More has been ordered and should be here today. Hippie, just a reminder, I know you had to stop working on yours for a while but before you put your floor on make sure you drill a hole in the back of your stringers to let any water that might get under the floor away to get out.

Looks killer!

[ Post made via HTC A6277 ]

Looks awesome man!

[ Post made via Android ]

Looks awesome!!! Great job so far.

Everything looks exactly like mine did as far as core and front floor. Great job. Keep it up, you'll be on the water in no time. Bill

Today I painted the inside of the boat with a expoy paint,this stuff dries hard as a rock. Then I glued down the front half of the floor.I left the back half out because I need to drill and bolt the L brackets that go on the bottom of the vulture. I have to change mine because they were pretty much rotten away. After I bolt them in I will glue the back half in. I am going to try the boat with out putting the vacuum tubes back, If it don't break loose I can always redrill them.
I have a ques. Does anybody know were I can get the extension for the steering wheel? I see you have one on your boat Hippie.

Rex marine

[ Post made via Android ]

Kenny maybe you 'll be done for the no name event in June in upper state New York........LOOKING GOOD............

Looks awsome Kenny