Few Pics...

[S P E E D]

Couple pics of the boats in the garage under Construction....


The J-Craft and Stream


Motor Stand ready



140 Rude off the stream ready to go on the J-Craft



Motor on the stand

[S P E E D]

Best 200 bucks ever spent! 1320 Pound lifting capacity and it worked great

[Hippie459MN]

I always did love the Visions. Like a mini vking. That j-craft looks great too

That motor stand is looking great too. I have a feeling I will be needing one sooner then later.

[Rut311969]

Very nice .You race bikes or somthing? seen banners .Wish my garage was that clean it looks like a parts bomb went off at my place.

[S P E E D]

Hippie : Yeah the Motor stand is going to get alot of use. I have my 225 Johnson going on it once the J-Craft Transom and floor is complete. (Lotsa pics of the coming!)

Rut: I Race Dragbikes and a Dirt Modified. The Banners up there are actually off this car I ran Last season....

[Rut311969]

We rum imca modifieds and my good friend is a 460 sprint driver we live a hr from knoxville Ia sprint car capital of the world if it anit dirt track its just follow the leader or I geuss they callit nass car see I loath it so much cant remember how to spell it lol

[S P E E D]

Couple more pics of the motor progress...

1992 bottom end with 93 powerheads 225 compltely gone through last year, Offshore mid section. Here's some pics of her bolted up and rigged last night.

Finished up some wiring, Throttle cables and fuel lines tonight.





Rear hatch plate is Marine Ply and I sealed it with some outdoor paint. Still have to cover it and wrap it with some Marine Vinyl I picked up. Speakers are low cause I'm going to make a Hydrostream logo above in the empty space.




I used the factory Cable hole but I made up a peice to hold the 2 inch hose adapters. The passenger side hose is over 2 inches to allow room for the gas filler cap. (Not installed yet)

[VultureNo2]

Looks real good. Bill

[Hippie459MN]

I like it. Looks good.

[Rut311969]

Yes I like the back board I"m thinking along the same lines for my Vector . Gives it a clean look in the back where oil and gas is it . Rest of the boat looks great to .