Well after I have been working bugs out of my motor I had a minor top end problem. If I would open it up WOT it wouldnt get up and go balls out. It would go but almost like it was 3/4 Throttle. So I tried gradually getting into the throttle instead of mashing it and it seemed to like it better but even still when I go WOT gradually it would slow down a hair then I pull an 1/8 or 1/4 out of the throttle and it pulls more then WOT. Also when I am just idling around cruising not on plane then go to plane the motor stuggles to get out of the hole and then I stop, put it in Neutral and rev it up to clean the plugs and go to plane again and it pulls better but still not like it should.
Now this weekend I figured I needed some fuel on the top end so I jetted from 60D's to 64D's Main fuel jets. Up top I seemed to have cured the WOT problem somewhat. But down low getting on plane I have to really work it to get up on plane.
It's almost like it's loading up when I am putting around and fouls up plugs, then once I go to plane it doesnt want to rock out until I stop, rev it to clean the plugs...and even then it doesnt haul *** out of the hole.
I think I might have a Coil pack going down but each Cyl plug has no signs of Fouling or over fueling. My other thought was this Offshore mid section exhaust. The two "Tuner exhaust ports" are still open, my thought is perhaps this exhaust is to big and then with the tuner holes still open when I Trim the motor down to plane the Offshore Mid Section gets submerged and it loads up the plugs with fuel choking it out.
I am putting fresh plugs in this weekend to see what happens with clean fresh plugs. My second thought was to check resistance and spec out the Coil Packs.
Any thoughts?
Wondering how to post images or maybe change your avatar or maybe something else?
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
Why is my motor...
-
- Random Topics
- Replies
- Views
- Last post
-
- 4Replies
- 81930 Views
- Last post by alaskastreamin
Feb 22, 2019 11:52 am
-
- 17Replies
- 174172 Views
- Last post by AdamDK
Dec 13, 2019 7:07 pm
-
- 2Replies
- 70473 Views
- Last post by Hippie459MN
Feb 24, 2019 10:11 am
-
-
Does anyone know of any Hydrostream emblems or decals available?
Last post by Shawnv-king « Mar 05, 2019 8:47 pm - 5Replies
- 89427 Views
- Last post by CleanV-King
Dec 29, 2020 11:32 pm
-
-
- 4Replies
- 80164 Views
- Last post by dehydrated
Mar 08, 2019 11:15 am
Who is online
Users browsing this forum: No registered users and 54 guests