Welcome to HydrostreamForums.com
If you're not registered, please consider doing so. It's easy - just click the "Register" link at the top
right corner of the page. Our forum needs members like you to contribute to the site in order to survive.
We are a community of boat lovers and Hydrostream enthusiasts here; we are happy to help anyone
who may need advice or guidance for their 'Stream; and we encourage members to offer their advice
and guidance to others as well. Thank you for visiting our forums, and please register.
We're better than Facebook.

Registering only takes a few minutes and you can do so by CLICKING HERE

If you are a member, don't forget to log in to take full advantage of the forum.

v king windshield side mounting screws something that looks better

Looking for help with your interior? What better place to ask then here.
Post Reply
User avatar

Topic Author
mitchielpricer
Getting my feet wet
Getting my feet wet
Posts: 64
Joined: Sep 24, 2013 6:38 pm
Location: kettering ohio

v king windshield side mounting screws something that looks better

Post by mitchielpricer » Jul 27, 2016 7:26 pm

just a question on the side mounting of the rear windshield rail that fits into the slot groove, a lot of opening design went into the slot only to just set the rail in and run 2 screws in it .. really it looks like a eye sore any ideas of a better way to make it look more finished that the bare screws seems like there would be a finished end cap that would look better and no be a snag hazard.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest