Hydrostreamforums.com - The only dedicated Hydrostream forum

Hey all, time for me to stop my hording ways. I have tons of Merc v-6 and inline parts I would sell, just a short list,
2.4 efi bridge port fronts, I have 3 no welds 2 have injsctor holes plugged but could be opened back up real e-z, $150 plus shipping for each
2.4 225 seven peddle front half, no welds $150 plus shipping.
2.4 seven peddle intackes for carbs I have two not cross drilled, $125 eachj pluss shipping.
Let me know what your looking for chances are good I have it

The 7 peddle setup is tempting but if I go any faster I will have to jump up a class.

You don't have a offshore trim bracket by chance?

I have a older one off a BP. Just have the two trans brackets with the trim ram, single ram of course

2.4 front half 7 petal? If so, GIMMIE! Let me know where to send funds.

hst4me. yes it is a seven petal 2.4 front half for carb motor came off a 225 without oil injection, also have a intake for it that is not cross drilled, make you a package deal for $225 plus the ride or $150 for just the front, plus shipping

DO YOU HAVE A TRIM SENDER FOR A EARLY 80'S SINGLE RAM MID THE ONE WITH THE LITTLE STAINLESS STRAP AND IT HAS A BLADE THAT LOCKS IN SLOT ON TILT PIN

still have this stuff plus much much more