I have been asking around but no one seems to have a good answer. Here is my problem I have a cmc 6 inch manual plate. The plate is in the top holes on the transom side and the motor is one hole from the top of the motor bracket. With everything topped out I am at just over 4 1/2 inches below the pad with the prop shaft. Need to go higher, but I am looking for a good way to do so or a suggestion on what to buy.
I can buy extensions for the cmc plate that is on it. I would just buy a new manual plate if I new it would get the motor high enough with out extensions. What is everyone running to get a 20inch motor even with the pad and still have adjustment up and down.
[ Post made via Android ]
Wondering how to post images or maybe change your avatar or maybe something else?
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
You can find that and a lot of other useful tips for using the forums in the HydrostreamForums Knowledge Base.
To visit the HydrostreamForums Knowledge Base CLICK HERE
How to get motor higher on a vulture?
-
- Regular
- Posts: 174
- Joined: Jun 03, 2012 8:29 pm
- Location: MA
- Been thanked: 6 times
- Contact:
Re: How to get motor higher on a vulture?
lets see a picture please.. the way you explained it i think you can bolt the motor higher on the boat and or jackplate..
-
- Random Topics
- Replies
- Views
- Last post
-
- 8Replies
- 5915 Views
- Last post by varmint1
Nov 21, 2012 7:19 pm
-
- 6Replies
- 4350 Views
- Last post by RussF
Nov 21, 2012 4:06 pm
-
- 4Replies
- 3850 Views
- Last post by juliarobert
Dec 11, 2012 11:53 pm
-
- 35Replies
- 12063 Views
- Last post by aaron78viper
Apr 03, 2013 10:53 am
-
- 18Replies
- 11805 Views
- Last post by nosboss
Jun 20, 2014 2:31 pm
Who is online
Users browsing this forum: No registered users and 5 guests