Thanks for the input Ron!
Ill try to get pics up after work late tonight..
Soo, I went over the hull bottom again in better light and found a hairline crack on the left vertical edge that goes down to the center pad--- so I ripped the floor out and found an old shoddy repair, and also NO CORE IN THE PAD!! At least the back 6ft anyways its just solid glass!!??
So, I've got a few sheets of 1/2" balsa and some 12" 1708 animal and fillers for the resin etc..
Im thinking of grinding to good clean glass, laying mat then 2 rush of 1708 12" overlapping an inch or so in the center of the pad, then maybe 1 or 2 more layers of mat --- also thinking maybe laying the balsa on that OR maybe making stringers for each side of the center pad..
Not sure at this point but between doing a huge fiberglass repair to my family's pool and then running over to grind more on the inside of the Virages center pad to get it ready to at least lay up the mat and 1708 im keeping busy! !
Just gotta figure the best way to do the center pad so its rock solid! !
Any input would be appreciated greatly!!-
And ill try my best to post pics late tonight when I get off work (2nd shift sucks!!)...
Oh, and I didn't get a notice you had replied to my thread or i would have replied right away! !
Thank you again and in advance for any more guidance too!! -- Shawn
[ Post made via Android ]